That said, you can download the x 64 drivers Windows XP/Server 2003 from this link. For the Designjet you can have better results, post it in the forum HP Designjet business here. This forum focuses on the level of consumer products. I updated my PC win-7 64-bit, I have the DesignJet 650 c plotter, but do not have the driver. These drivers work fine for Windows 7 x 74 (and also Windows 8 x 64) you can install the XP x 64 drivers as described in this post. Once the plot ends at halfway in the page search for MIO, the IP address for the plotter configuration information will be available on the right side of the page.Īt this point your plotter is set up and ready, then get the driver installed on your PC.

Then press ENTER, down arrow until you get to the utility, enter, down arrow for plot, Enter Config. Press previous return to main menu of status. At this point theCfg network = NO * reappears, it is normal. Then, press Enter façade, then arrow down three times to get to, Enter, modular i/o of installation configuration, come in, Cfg network = NO, Enter, arrow for Yes. The 650 c and connect it to your router with a LAN cable. Yes, it's exactly the setup I have (with a JetDirect card installed in the 650 c).

I would like to know if a DesignJet 650 c (C2858B) with a JetDirect card can be installed via the LAN on a PC running Windows 7 (64 bit)? If Yes, could someone please advise on how to do it? HP DesignJet 650 c on Windows 7 x 64 via LAN with JetDirect adapter

Pl532en 64 bit